Quiet Darkroom

· Printing · FP4 Plus, HP5 Plus · 2 min read

First prints with a second-hand enlarger

An enlarger bought from a retiring club member, three trays in the bathtub, and the first time a picture appeared on paper under the safelight.

Making prints under an enlarger in a photographic laboratory.
Making prints under an enlarger in a photographic laboratory.

Scanning had been my only way of seeing my pictures for almost two years. In November a camera club nearby cleared out an old darkroom, and I came home with an enlarger, a 50 mm lens, a set of multigrade filters and a safelight, all for the price of a few rolls of film.

A street at night under an elevated railway.
A street at night under an elevated railway.

Setting it up

The enlarger stands on a board laid across the bathtub, which puts the baseboard at a comfortable height if I kneel. Three trays sit in the tub beside it: developer, stop and fixer, then a bucket of water for the prints to wait in. The safelight hangs from the towel rail, more than a metre from the paper as the box says, aimed at the ceiling.

Before printing anything I did a safelight test: a sheet of paper, half covered with a card, left under the safelight for four minutes, then developed. No difference between the two halves. Good.

The first print

I chose a frame of FP4 I knew was well exposed, a street corner in low winter sun. A test strip at f/8 with three-second steps showed the right density around twelve seconds with no filter. The first print looked muddy. With a grade 3 filter and fourteen seconds, it came alive.

Watching that picture rise in the developer under the orange light is the best part of the whole hobby. I knew the frame from the screen, but it looked different on paper: quieter, with a texture in the shadows the screen had never shown.

A historic street in winter light, with fire escapes and old snow.
A historic street in winter light, with fire escapes and old snow.

Split-grade, a little later

By the second weekend I had started printing with two filters: a soft grade 00 exposure that sets the highlights, and a hard grade 5 exposure that sets the blacks. It sounds complicated and is actually simpler than guessing grades, because each exposure controls one end of the scale.

PaperDeveloperStopFixWash
RC multigrade60 s, 1+910 s60 s, 1+42 min running water
A street of tall old houses at dusk.
A street of tall old houses at dusk.

I still scan everything first, to choose what to print. But the prints on the wall in the hallway are all from the bathtub now.

— Elin, 14 December 2025